How-to

What humidity should your home be? How to read a hygrometer

The humidity range UK advice gives, why a cold room reads higher, what the patterns on a cheap hygrometer mean and what to do when it stays high.

By Checked and updated

On this page (10 sections)

Aim for 40 to 60% relative humidity. The Centre for Sustainable Energy (CSE) puts it this way: “It is recommended to keep RH levels in the home between 40-60%; there is a risk of mould growth when RH goes above 60%.” (CSE, condensation, damp and mould).

So 68% in the bedroom is above the range, but one reading on its own means little. Humidity rises every time someone showers, cooks or hangs washing, and falls again when the steam gets out. What matters is the pattern: a room that sits above 60% for most of the night, every night, or a room that never comes back down.

Drynook has not tested any hygrometer or dehumidifier; everything here comes from the published sources listed at the end.

What relative humidity actually measures

Relative humidity (RH) is how close the air is to holding all the water vapour it can at its current temperature. The Met Office describes it as indicating “how close the air is to being saturated with water vapour at a given temperature”, and adds that “Warmer air can hold more water vapour than cooler air”. At 100%, the air is saturated.

The key word is relative. Take the same air, with the same amount of water in it, and cool it down: it can hold less, so the percentage goes up. That is why a cold back bedroom often reads higher than a warm living room in the same flat, even when nothing in the bedroom is producing extra moisture.

A worked example

The US National Weather Service publishes a standard formula for how much water vapour air can hold at a given temperature (its vapour pressure calculator and formula sheet): saturation vapour pressure in hectopascals = 6.11 × 10^(7.5T ÷ (237.3 + T)), with T in °C. RH is the actual vapour pressure divided by that figure. Working it through for air at 20°C and 60% RH:

Same air, cooled to Reads about
20°C 60%
18°C 68%
15°C 82%
12°C 100% (saturated)

Figures rounded, worked out with the formula above.

Two things follow. First, a 68% reading in a bedroom at 18°C holds no more water than 60% in a living room at 20°C; the difference is the temperature. That is why a hygrometer that shows temperature too is so useful. Second, that air becomes saturated at about 12°C, which is its dew point.

Dew point: why the window gets wet when the room reads “fine”

The Met Office defines dew point as “the temperature at which air becomes saturated and water vapour condenses”. Any surface colder than the dew point of the air touching it will get wet.

In the example above, room air at 20°C and 60% reads exactly at the top of CSE’s range. But if the window glass, or the corner of an outside wall behind the wardrobe, is at 12°C or below, the air touching it reaches 100% and water condenses there. The hygrometer on the shelf measures the room’s air, not that cold patch.

CSE describes the same thing: when moist air reaches cool walls, ceilings, windows and pipes, it “turns back into water (condenses) making those surfaces damp.” The government’s damp and mould guidance for housing providers names the usual places: “window frames, corners and low points on walls behind sofas or wardrobes”.

This is why the cold spots get mould first, and why heating and insulation matter as well as ventilation.

When to take readings, room by room

CSE’s guide to testing humidity at home suggests readings in various rooms at different times, including:

Add the room where the washing dries, while it is drying. CSE also notes that most monitors don’t store information, so you will need to write the readings down unless yours keeps a history. A line in a notebook with the time, room, humidity, temperature and what was happening (shower, clothes horse out, heating off) is enough.

CSE is relaxed about short peaks: “Humidity will increase when you shower, take a bath, cook or dry your clothes.” And: “A well-ventilated home will regularly exchange the air inside with fresh air, so provided your readings quickly come back down to healthy levels, it’s nothing to worry about.”

What the pattern usually means

What you see What it usually means What to do
Spikes after a shower, then falls Normal; the steam is getting out Extractor on, door shut, window open
High in the bedroom every morning Overnight moisture has nowhere to go Trickle vents open; air the room in the morning
High all day in one cold room Low temperature pushes RH up Heat it regularly; check for cold spots
High while washing dries Laundry moisture Dry it in a closed room with a window open
In range, but mould in one corner A cold surface or a building fault Look at the wall, not the meter
Below 40% in a heated room Below the bottom of CSE’s range Switch off any dehumidifier

The actions come from CSE’s checklist and the government guidance above. The rest of this guide explains each one.

When it stays too high: what to try, in order

Work from the source of the moisture outwards. Our condensation checklist has the detail; this is the order.

1. Ventilation and extraction where the steam is made. CSE says to open kitchen and bathroom windows “to allow the steam created by cooking, showering or having a bath to leave the building”, to check extractor fans are clean and working and switched on whenever steam is produced, and to keep trickle vents open. Keep the kitchen and bathroom doors closed while you cook or shower, so the moisture does not spread round the house.

2. Heating. CSE advises turning the heating on regularly in colder months: “This doesn’t mean all day, every day, but often enough to keep the home dry.” A warmer room reads lower and its walls sit further above the dew point.

3. Where the washing dries. CSE says to avoid drying laundry inside if you can, and if not, to spin it twice and “hang the washing in a room with the internal door closed and a window open.” Our guide to the cheapest way to dry clothes indoors compares the options.

4. Then a dehumidifier. CSE’s checklist ends: “In severe cases, use a dehumidifier.” If you use one, CSE’s advice on the setting is: “Set your dehumidifier to under 60% humidity if possible.” It also says closing the doors and windows of the room the dehumidifier is in helps it work more efficiently, and that “On warm, dry days, opening a window will be just as effective as running a dehumidifier.” For which machine suits which room, see the dehumidifier buying guide.

Is there such a thing as too dry?

CSE’s range has a lower end of 40% as well as an upper end of 60%. Its testing guide says: “Humidity that is too high or low can also encourage the growth of bacteria, viruses and mites and make you more prone to respiratory infections, allergies, rhinitis and asthma.” That is CSE’s statement, quoted as it stands; Drynook does not give health advice, and health questions belong with the NHS or a GP.

In practical terms, if a heated room is reading under 40% and a dehumidifier is running, it does not need to be. If the reading sits low and nothing is drying the air, note it in your log alongside the temperature.

How far to trust a cheap sensor

A household hygrometer is a guide, not a laboratory instrument. Makers publish their own tolerances. SwitchBot’s Meter Plus page gives ±2% between 10 and 90% RH, widening to ±4% outside that. TempPro’s calibration page says its digital thermometers “have an accuracy of 2-3%RH” and puts analogue hygrometers at 10%RH. So a sensor showing 62% could be in the range; one showing 68% almost certainly is not.

Some practical checks:

If you have not bought one yet, the hygrometer guide explains why SwitchBot’s published accuracy figures made the Meter Plus its pick.

When the numbers are not the problem

If the room reads within 40 to 60% most of the time but damp or mould keeps coming back in one place, the meter is telling you the air is not the main cause. Look for a cold spot, a leak or a building fault. CSE’s page covers penetrating damp, which “may get worse when it rains”, and rising damp, which leaves a “tide mark” on skirting boards or walls. Our guide to black mould in the bedroom goes through the causes and what to do.

A log of readings is useful evidence. The government’s guidance for housing providers lists “consistently high relative humidity, as assessed using a moisture meter or environmental monitors” among the internal checks a landlord should make, alongside visible condensation and broken extractors. It also says smart sensors “should not be misused as tools to blame tenants”. If you rent in England, our guide to mould in a rented home explains what that guidance and the law say about who has to fix it.

Questions people ask

Is 70% humidity too high in a house?

As a regular reading, yes: CSE says there is a risk of mould growth above 60%, and Welsh Government guidance for landlords links dampness to increased humidity, “especially beyond 70 per cent”. A brief 70% after a shower is a different matter; CSE says it is nothing to worry about if readings quickly come back down. Check what the room reads an hour or two later and over several days.

What should humidity be in a bedroom at night?

The same 40 to 60% CSE gives for the rest of the home; it does not set a separate night figure. CSE suggests checking bedrooms when you wake up, because that is when overnight moisture has built up. A bedroom that is above 60% most mornings needs more ventilation or heat, or a closer look at where the moisture comes from.

Why is my humidity higher in winter?

It depends on temperature as much as moisture. Cooler air holds less water vapour, so the same moisture reads higher in a colder room, and in winter rooms and walls are colder, windows stay shut and washing more often dries indoors. Read the humidity together with the temperature before deciding the air has got wetter.

Does opening a window lower humidity?

Usually, yes, because it lets moist air out. CSE says that on warm, dry days opening a window is just as effective as running a dehumidifier, and recommends opening kitchen and bathroom windows while cooking and showering. Government guidance suggests opening the window wide and closing it once the air in the room has changed, rather than leaving it open all day.

Sources checked on 16 November 2026